Compartir
Co2 Laser Cutting of Carbon Fiber Reinforced Polymer (Cfrp) (en Inglés)
Alok Sharma
(Autor)
·
Amit Tiwari
(Autor)
·
Himanshu Vasnani
(Autor)
·
Scholars' Press
· Tapa Blanda
Co2 Laser Cutting of Carbon Fiber Reinforced Polymer (Cfrp) (en Inglés) - Sharma, Alok ; Tiwari, Amit ; Vasnani, Himanshu
$ 54.47
$ 64.69
Ahorras: $ 10.22
Elige la lista en la que quieres agregar tu producto o crea una nueva lista
✓ Producto agregado correctamente a la lista de deseos.
Ir a Mis ListasSe enviará desde nuestra bodega entre el
Lunes 03 de Junio y el
Martes 04 de Junio.
Lo recibirás en cualquier lugar de Estados Unidos entre 1 y 3 días hábiles luego del envío.
Reseña del libro "Co2 Laser Cutting of Carbon Fiber Reinforced Polymer (Cfrp) (en Inglés)"
The purpose of research in this book is to cut a 1mm thick Carbon fibre reinforced polymer (CFRP) by using a low power CO2 laser cutting speed (1-2mm/sec) and assist gas pressure (1-2bar). Main objective of this research work is to lower production cost of cutting by using lower laser power. A Composite of Carbon Fibre (carbon fibre + epoxy resin) with initial dimensions of 120mm×100mm×1mm was used as a material for laser cutting. A CO2 laser machine of maximum laser power 150 watt was used for laser cutting. Rectangle cuts of 50mm×40mm were cut through CFRP sheets. Samples size was determined according to response surface methodology (RSM). Factorial design was used to determine number of experiments. According to this design, number of experiment was eight. Experiments were conducted according to this design. Experiments were conducted by changing process parameters (laser power, cutting speed and assist gas pressure) simultaneously. After laser cutting, scanning electron microscope was used to see effect of process parameters on material surface in the form of microstructure. Optimization was done by the use of MINITAB software.The purpose of research in this book is to cut a 1mm thick Carbon fibre reinforced polymer (CFRP) by using a low power CO2 laser cutting speed (1-2mm/sec) and assist gas pressure (1-2bar). Main objective of this research work is to lower production cost of cutting by using lower laser power. A Composite of Carbon Fibre (carbon fibre + epoxy resin) with initial dimensions of 120mm×100mm×1mm was used as a material for laser cutting. A CO2 laser machine of maximum laser power 150 watt was used for laser cutting. Rectangle cuts of 50mm×40mm were cut through CFRP sheets. Samples size was determined according to response surface methodology (RSM). Factorial design was used to determine number of experiments. According to this design, number of experiment was eight. Experiments were conducted according to this design. Experiments were conducted by changing process parameters (laser power, cutting speed and assist gas pressure) simultaneously. After laser cutting, scanning electron microscope was used to see effect of process parameters on material surface in the form of microstructure. Optimization was done by the use of MINITAB software.
- 0% (0)
- 0% (0)
- 0% (0)
- 0% (0)
- 0% (0)
Todos los libros de nuestro catálogo son Originales.
El libro está escrito en Inglés.
La encuadernación de esta edición es Tapa Blanda.
✓ Producto agregado correctamente al carro, Ir a Pagar.
